Hardware Installation; Consult Your Dealer For The Correct Installation Of Peripheral Devices - Abus eyseo. TV7230 Instructions D'installation

Hardware installation

To prevent the risk of electric shock, first connect the socket of the transformer to the
PAN/TILT-network camera before inserting the transformer into the mains socket.
When you switch on, the red LED on the front lights up and the start procedure begins. During the
start procedure, the blue, red and green LED are all active. This state continues until an IP address is
defined. After you define the IP address, the green LED flashes once a second. For troubleshooting
hints, see Appendix.

Consult your dealer for the correct installation of peripheral devices.

The PAN/TILT network camera first tries to address the wired Ethernet. If it cannot reach this, the
camera tries to reach the wireless network (WLAN). During the search and connection process to the
wireless access point, the red LED on the network camera flashes once a second. The red LED
remains in this state until the connection to an access point is established. During operation in the
WLAN or wired mode, the green LED flashes constantly once a second to show this activity.
Installation in the Ethernet
Make sure that the camera is directly connected to a PC (cross-link cable) or via a switch/hub to the
network. Now connect the network adapter of the camera to the mains network. When the camera is
correctly connected to the network, the blue LED on the front lights constantly. If no network is
available, the camera switches to WLAN mode.
Installation in the WLAN
If the camera is supplied with electricity and no Ethernet is available, the camera switches to WLAN
mode and searches for an access point with the name "default". This name is known as the SSID
(Service Set Identifier). If an access point with the SSID "default" is found, the LED on the front lights
blue.
If connection with the basic settings (SSID: default) is not successful, connect the camera via a cable
to the wired network and configure it.
Make sure that all accessories and articles
listed above are present in the scope of
delivery. Depending on application, an Ethernet
cable may be required. This Ethernet cable
must meet the specifications of UTP Category
5 (CAT 5) and must not be longer than 100
meters.
6