Closing The Door - Kuppersbusch IKE2480-1 Notice D'utilisation

Problem
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Water flows on the
ground.
The temperature in the
appliance is too low.
The temperature in the
appliance is too high.
Upper or lower square is
shown in the tempera-
ture display.
dEMo appears on the
Display.
Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the light-
ing device. Contact your Service Center .

Closing the door

1. Clean the door gaskets.
Possible cause
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
During the automatic defrosting
process, frost defrosts on the
rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
The melting water outlet does
not flow in the evaporative tray
above the compressor.
The temperature regulator is not
set correctly.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
An error has occurred in meas-
uring the temperature
The appliance is in demonstra-
tion mode (dEMo)
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature be-
fore storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Call your service representative
(the cooling system will continue
to keep food products cold, but
temperature adjustment will not
be possible).
Keep pressed approximately 10
sec. the OK button since a long
sound of buzzer is heard and the
Display shut off for a short while:
appliance start works regularly.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
19
Solution