Samsung RZ28H6165SS/WS Mode D'emploi page 12

REVERSING THE FREEZER
DOOR
Samsung recommends that reversing of the
door opening is only completed by Samsung
WARNING
approved Service providers. This will be on
a chargeable basis and at the customers
expense.
Any damage caused while attempting to
reverse the door opening is not covered
under the appliance manufactures warranty.
Any repairs requested due to this
circumstance will be completed on a
chargeable basis at the customers expense.
Required Tools (Not provided)
Phillips Head Flat Head
Driver (+) Driver (-)
8 mm
Spanner
Socket Wrench
(for hinge shaft)
(for bolts)
DA68-03009G-03.indb 12 DA68-03009G-03.indb 12
1. Remove 4 screws on the top of the freezer.
2. Remove the plastic cover and make sure to
disconnect the wire connected to it.
After removing the plastic cover, check the parts
for reversing the door.
10 mm CAUTION
Socket Wrench
(for bolts)
3. Disconnect the wires and then remove 3 bolts.
5 mm Hex
Wrench
(for bottom
hinge shaft)
WARNING
English - 12
Be careful not to damage the electrical wires
when removing the plastic cover.
Make sure your freezer is unplugged before
handling electrical wires.
15. 1. 6. 15. 1. 6. 8:21 8:21