crockpot 6Qt Manuel Du Propriétaire page 20

CARE AND CLEANING (CONT.)
dry thoroughly, and replace Sealing Gasket in Lid before
use. Leave the Lid upturned for storage, as this will also
extend the life of the gasket. Sealing Gasket may need to
be replaced every 1 – 2 years depending on regular use.
Contact Crockpot customer service or visit
TM
www.crockpot.ca to order replacement parts.
Steam Release Valve
Ensure the Steam Release Valve (see Figure 1) is clear from
debris before you begin using the Cooker. Remove the valve
(see Figure 7) and gently clean. Ensure it is completely dry
before replacing.
Steam Release Valve Cover
The Steam Release Valve Cover is on the underside of the Lid
(see Figure 8). Ensure it is clear from debris before you begin
using the Cooker. To clean, carefully pull the cover off and
clean using warm, soapy water. Press the cover back into its
place after cleaning is complete.
Valve REMOVE
Figure 7
-E38-
CARE AND CLEANING (CONT.)
UNDERSIDE OF Lid
Bobber Valve
Steam Release Valve
Cover
Figure 8
Bobber Valve
Gently press the valve up and down 2-3 times and ensure it
is clear from debris before you begin using the Cooker.
Lid Lock Pin
Gently press the pin and ensure it is clear from debris before
you begin using the Cooker.
Note:
1. Condensation may collect inside the Heating Base under
the removable Cooking Pot. This is normal. Allow to
cool, and then dry using kitchen cloth.
2. Always make sure that each component (pot, valves,
gasket, etc.) is completely dry before you put back into
the Cooker.
-E39-