Kuppersbusch ITE127-9 Mode D'emploi page 23

Ventilation requirements
The airflow behind the appliance must be
sufficient.
min.
200 cm
Installing the appliance
Caution! Make sure that the mains
cable can move freely.
Do the following steps:
1. If necessary cut the adhesive sealing
strip and then apply it to the appliance
as shown in figure.
2
min.
200 cm
2
x
2. Install the appliance in the niche.
Push the appliance in the direction of
the arrows (1) until the upper gap cover
stops against the kitchen furniture.
Push the appliance in the direction of
the arrows (2) against the cupboard on
the opposite side of the hinge.
3. Adjust the appliance in the niche.
Make sure that the distance between
the appliance and the cupboard front-
edge is 44 mm.
The lower hinge cover (in the accesso-
ries bag) makes sure that the distance
between the appliance and the kitchen
furniture is correct.
Make sure that the clearance between
the appliance and the cupboard is 4
mm.
23
x
2
1