After Use - Nilfisk Retriever 6250 SR 1800 Mode D'emploi

A-14 / ENGLISH

AFTER USE

1 Shake the Hopper Dust Control Filter (10) and empty the hopper.
2 Check the maintenance schedule and perform all required maintenance before storage.
3 Move the machine to an indoor storage area.
4 Shut down the engine according to the shut down procedures.
5 Make sure the Ignition Key Switch (52) is OFF and the Parking Brake (3) is engaged.
TO SHUT DOWN THE GASOLINE ENGINE...
1 Turn all controls to the OFF position.
2 Raise the brooms.
3 Place the Engine Speed Switch (42) in IDLE and let the engine idle for 25 - 30 seconds.
4 Turn the Ignition Key Switch (52) OFF and remove the key.
5 Apply the Parking Brake (3).
TO SHUT DOWN THE PROPANE ENGINE...
1 Turn all controls to the OFF position.
2 Raise the brooms.
3 Turn the service valve on LP Gas Tank (23) OFF.
4 Run the engine until all the LP gas is dispelled from the line (the engine will stall).
5 Turn the Ignition Key Switch (52) OFF and remove the key.
6 Apply the Parking Brake (3).
TO SHUT DOWN THE DUAL FUEL ENGINE...
1 Select propane fuel (54) and follow the propane shut down procedures.
TO SHUT DOWN THE DIESEL ENGINE...
1 Turn all controls to the OFF position.
2 Raise the brooms.
3 Place the Throttle Control (60) in IDLE and let the engine idle for 5 minutes.
4 Turn the Ignition Key Switch (52) OFF and remove the key.
5 Apply the Parking Brake (3).
REPORT ANY DEFECT OR MALFUNCTION NOTED DURING OPERATION TO AUTHORIZED SERVICE OR MAINTENANCE PERSONNEL.
A-14 - FORM NO. 56041556 - Retriever
™
6250 / SR 1800