Dryer Disposal; Installation Requirements; Tools And Parts; Location Requirements - Maytag MDG17MN Instructions D'installation

Tools and Parts

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Tools needed:
200 mm (8") or 250 mm
I
(10") Pipe wrench
200 mm (8") or 250 mm
I
(10") Adjustable wrench
Flat-blade screwdriver
I
Phillips screwdriver
I
Adjustable wrench that
I
opens to 25 mm (1") or
hex-head socket wrench
Level
I
Parts supplied:
Remove parts bag from dryer drum. Check that all parts were
included.
Foot boot (4)
I
Dryer foot (4)
I
NOTE: The circuit diagram for this dryer is located inside
the lower front panel.
4

DRYER DISPOSAL

INSTALLATION REQUIREMENTS

8 mm (5/16") socket wrench
I
Utility knife
I
Vent clamps
I
Pipe-joint compound
I
resistant to LP gas
Caulk gun and caulk
I
(for installing new
exhaust vent)
Pliers
I
Putty knife
I

Location Requirements

If installing a gas dryer:
IMPORTANT: Observe all governing codes and ordinances.
I Check code requirements: Some codes limit or do not permit
installation of clothes dryers in garages, closets, or sleeping
quarters. Contact your local building inspector.
I Make sure that lower edges of the cabinet, plus the back and
bottom sides of the dryer, are free of obstructions to permit
adequate clearance of air openings for combustion air. See
"Recessed Area and Closet Installation Instructions" on next
page for minimum spacing requirements.
NOTE: The dryer must not be installed in an area where it will be
exposed to water and/or weather.