Friedrich QuietMaster SS Instructions D'installation page 3

STEP 1 STEP 1
STEP 1 STEP 1 STEP 1
Remove decorative plastic return air grille to a safe area away from unit. The return air grille can be
removed by pulling at the sides on either the top or bottom.
STEP 2 STEP 2 STEP 2
STEP 2 STEP 2
Also remove the installation hardware to a safe area away from the unit.
STEP 3 STEP 3 STEP 3 STEP 3 STEP 3
Remove the chassis retainer by removing the far right screw in the basepan (see Figure A); save this
screw to reattach the chassis retainer after installation (Step 15). Also, remove and discard the two
retainer screws and plastic bushings located at the rear of the unit.
STEP 4 STEP 4 STEP 4 STEP 4 STEP 4
While an assistant holds the cabinet stationary, use the hand pull at the front of the base pan (see
Figure A) to pull the chassis out of the cabinet. Remove white foam blocks used to restrain the compressor
during shipment. Inspect basepan for dislodged white blocks, and remove. Do not remove any other
foam.
FIGURE A
STEP 5 STEP 5 STEP 5
STEP 5 STEP 5
Anchor the side angles (Item #6) by engaging the tabs at each end of the sill plate (see Figure B, Page
4) with the bottom loops of the side angle. Engage the tabs at each end of the top angle (Item #5) with
the top loops of the side angle (see Figure B, Page 4). Install two (2) screws (Item #7) to secure the top
angle tabs and the side angle to the cabinet (see Figure B, Page 4).
STEP 6 STEP 6
STEP 6 STEP 6 STEP 6
Check the window sill and frame to be sure they are in good condition and firmly anchored to the wall.
Repair if necessary.
STEP 7 STEP 7 STEP 7 CABINET MOUNTING: CABINET MOUNTING: Raise the lower sash window ¼" more than the height of the cabinet. Carefully slide CABINET MOUNTING:
STEP 7 STEP 7 CABINET MOUNTING: CABINET MOUNTING:
the cabinet through the open window until the sill plate channel rests behind the window sill and the
top support rests against the window (see Figure C, Page 4.) Center side to side and drill three (3) 5/32"
dia. pilot holes into the window sill using the holes in the cabinet sill plate as a guide. Install three (3)
#12A x 2" long screws (Item #4), see Figure C, Page 4.
ST ST ST ST STAND AND ANDARD SASH WINDOW INST AND ARD SASH WINDOW INST ARD SASH WINDOW INSTALL ARD SASH WINDOW INST
AND ARD SASH WINDOW INST
HAND PULL
CHASSIS RETAINER SCREW
ALLA A A A A TIONS ALL ALL TIONS TIONS TIONS
ALL TIONS
CABINET
HAND PULL
CHASSIS
RETAINER WIRE
Page 3