Kimpex CLICK N GO 2 Mode D'emploi page 7

"CLICK N GO 2" PLOW ATTACHMENT
P P olaris – RZR, Mid-Size
5) Insert the two (2) square bend U bolts
the frame and floor of the vehicle, pass in the holes
drilled in the previous step, and secure with four (4)
M8-1.25 hex. nuts . Each U-bolt
C
the frame and the skid plate of the vehicle, the rear
bracket and the attachment plate
03
C
06
Front of
the vehicle
6) Tighten all bolts and nuts assembled so far with an
appropriate tool.
Assembly of the V-Plate to the Attachment
Plate
7) Assemble the four (4) M8-1.25 x 25 mm carriage
bolts and four (4) M8-1.25 hex. nuts
B
V-plate in the holes corresponding to the width of
A
the four (4) slotted holes of the attachment plate
Screw the first threads only so as to leave a space
between the head of carriage bolts
V-plate .
A
KIMPEX INC. / 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA / 100 Walnut Street / Champlain, New York / 12919
2810520 A A -2810520 Printed in Canada
ASSEMBLY INSTRUCTIONS
between
E
must connect
E
.
01
E
05
08
01
on the
C
01
and the
B
8) Assemble one (1) M8-1.25 x 20 mm hex. bolt
one (1) M8-1.25 hex. nut
V-plate . Tighten the bolt with an appropriate tool.
A
A
03
9) Assemble the V-plate
by first aligning the rear carriage bolts
front carriage bolts
10) Once the carriage bolts
of the slotted holes of the attachment plate
tighten them well using an appropriate tool.
Position of the Push Frame Hook Assembly
Install the push frame hook assembly in Position 3. Refer
to the instructions for the push-frame for the assembly
procedure. It is possible that the position must be
changed to fit the winch installed on the vehicle.
.
374472
KIMPEX NO.
at the front centre of the
C
B
D
C
on the attachment plate
A
, then the
B
.
B
01
are inserted to the bottom
B
and
D
01
E
B
,
01
3