Locking; Opening; How To Use; Storage - Hartmann 10028372 Mode D'emploi

5.2 | Locking

• Select a stable object to fasten to. Loop the cable around the object and insert the
eyelet-shaped end into the body of the lock.
• Press the elongated locking button until you hear an audible click. Reset the numbers
to a random combination. Check that the lock locks securely.

5.3 | Opening

• Set the selected combination to open (factory setting 0-0-0-0).
• Press the round release button. The elongated locking button pops out, and the cable
can then be removed from the body of the lock.

6 | How to use

Find a suitable object to which you wish to fasten your helmet, sports equipment,
luggage etc. The object should not be moveable, and must be sufficiently large and
heavy. You can form two loops, for instance, as shown in the figure. One holds the
object, e.g. the chin piece of a motorcycle helmet, the other is wrapped around the
fastening object, e.g. the motorcycle frame. Then lock the cable lock as described and
set the numbers to a random combination.

7 | Storage

Store the cable lock in a closed room which is protected from the weather and
moisture. The air humidity should not exceed 80% (non-condensing).

8 | Cleaning and care

Only ever clean the cable lock by hand with warm soapy water and a soft cloth. Never
use harsh cleaning products or similar. Oil the locking mechanism after cleaning as
necessary with a little fine oil.
14