Black & Decker LST136 Mode D'emploi page 12

• Wind the cutting line onto the spool in
the direction of the arrow on the spool.
Make sure to wind the line on neatly and
in layers. Do not crisscross (figure U).
• When the wound cutting line reaches
the recesses (T2), cut the line. (figure T).
• Fit the spool onto the tool as described
in "REPLACING THE SPOOL".
Maintenance
WARNING:
To avoid serious injury, remove the battery from
the tool before performing any maintenance.
1. Keep the air intake slots clean to avoid overheating.
2. Your trimmer line can dry out over time. To keep your line in top
condition, store spare pre-wound spools or bulk line in a plastic,
sealable bag with a tablespoon of water.
3. Plastic parts may be cleaned by using a mild soap and a damp rag.
4. The line cutter on the edge of the guard can dull over time. It is
recommended you periodically touch-up the sharpness of the
blade with a file.
IMPORTANT: To assure product SaFETY and RELIaBILITY,
repairs, maintenance and adjustment should be performed by
authorized service centers or other qualified service organizations,
always using identical replacement parts.
THE RBRC™ SEAL
The RBRC™ (Rechargeable Battery Recycling
Corporation) Seal on the Li-Ion battery (or battery pack)
indicates that the costs to recycle the battery (or battery pack) at
U
the end of its useful life have already been paid by Black & Decker.
RBRC™ in cooperation with BLACK+DECKERand other battery
users, has established programs in the United States to facilitate the
collection of spent Li-Ion batteries. Help protect our environment and
conserve natural resources by returning the spent Li-Ion battery to
an authorized BLACK+DECKERservice center or to your local retailer for
recycling. You may also contact your local recycling center for information on
where to drop off the spent battery.
Rechargeable Battery Recycling Corporation.
This device complies with part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment. This Class B digital apparatus complies with
Canadian ICES-003.
12
is a registered trademark of the
RBRC™