Dometic SINEPOWER MSI912 Instructions De Montage page 22

Connecting the inverter
9.8 Connecting the external switch for turning on and off
I
NOTE
Use cables with a cable cross section of 0.25 – 0.75 mm².
You can use the following as an external switch:
• external switch, voltage supply from the inverter: fig. 0, page 7
• Control unit with relay or transistor circuit (TR): fig. a, page 7
• external switch with voltage supply from the battery (BAT) of the vehicle: fig. b,
page 7
• external switch with its own voltage supply (DC POWER) e.g. from the ignition:
fig. c, page 7
➤ Set the main switch (fig. 6 1, page 4 and fig. 7 1, page 5) to "OFF" and make
sure that the connection for the remote control (fig. 5 2, page 4) is not
assigned.
➤ Set the main switch (fig. 6 1, page 4 and fig. 7 1, page 5) to "REMOTE".
➤ Connect the external on/off switch with the connection cable to the terminal
(fig. 5 1, page 4).
22
SinePower
EN