Range Cleaning Recommendations - Thermador Professional Pro-Grand PD304 Manuel D'utilisation Et D'entretien

Section SIX: CARE AND MAINTENANCE
Range Cleaning
When cleaning this range:
1. Use the mildest cleaning procedure
that will do the job efficiently and
effectively. Some cleaners of the same
type are harsher than others. Try on a
small area first.
2. Always rub metal finishes in the direction of the polish lines for
maximum effectiveness and to avoid marring the surface.
3. Use only clean soft cloths, sponges, paper towels, fibrous brushes,
plastic, non-metal or steel wool soap pads for cleaning and scouring,
as recommended on the chart.
4. Any part of this appliance can be cleaned with hot sudsy water.
When rinsing is required, rinse thoroughly.
5. Always wipe dry immediately to avoid water marks.
COOKTOP CLEANING RECOMMENDATIONS
Part / Material
Brass Burner Base
and Cast Iron Cap
Burner
Base
Burner
Cap
Star® Burner
Components
Control Knobs / Plastic
Bezels / Chrome
Please see Guide to Knob
Identification and Location
on Page 11.
CAUTION
Avoid cleaning any part of
the range while it's hot.
Suggested Cleaners
• Hot sudsy water; rinse and dry
thoroughly.
• Mild Abrasive Cleansers: Bon
® ®
Ami , Cameo Aluminum and
Stainless Steel Cleaner,
Wright's ® All Purpose Brass
Polish.
• Liquid cleaners: Kleen King
• Stiff nylon bristle tooth brush
to clean port openings.
• Reassemble as shown. Make
sure that the burner cap is
seated on the base.
• Hot sudsy water; rinse and dry
immediately.
37
Brand Names
The use of brand names is
intended only to indicate a type of
cleaner. This does not constitute
an endorsement. The omission of
any brand name cleaner does not
imply its adequacy or inadequacy.
Many products are regional in
distribution and can be found in
the local markets.
It is imperative that all products be
used in strict accordance with
instructions on the package.
The following chart gives directions
for cleaning this range.
Important Reminders
• Do not scratch or gouge the
port openings of burner
caps.
® .
• Do not soak knobs.
• Do not force knobs onto
wrong valve shaft.