Bresser 4Cast CS Mode D'emploi page 37

OUTDOOR SENSOR STATUS
The wave icon above the current channel icon shows the connection status of the corresponding
outdoor sensor:
Icon
SEARCH FOR OUTDOOR SENSORS
You can start searching for outdoor sensors manually by pressing and holding the [ ▼ ] button
for about 3 seconds. The wave symbol starts to fl ash. With this search option, the main unit
searches for the same outdoor sensor which has previously been recognized by the main unit.
If you have changed the battery in the outdoor sensor, then the sensor has received a new
identifi cation number and is then no longer recognized by the main unit. You can connect the
outdoor sensor with the new identifi cation number as follows: You need to start an advanced
search operation by pressing the [ ▼ ] button for 3 seconds and while the wave icon is fl ashing
you need to again press the [ ▼ ] button for 3 seconds. Then the temperature will begin to fl ash
and now a new outdoor sensor is searched.
VIEWING REMOTE (CHANNEL) TEMPERATURE
Static Display:
• Press the [CHANNEL] key to select measurements from different remote sensors, channel
1, 2, 3 or IN.
Channel Auto-Scan Display:
• Press To enable an automatic scan of all channels, press and hold CHANNEL, until the
is displayed. The measurements from each remote channel will be alternatively displayed with
a 5 seconds viewing.
Searching for the signals from the outdoor sensor
Corresponding outdoor sensor signal received successfully
No signals received for over 1 hour
37
Status
GB/IE
icon