Electrical Connection; Removing The Front Cover; Routing Wire To The Terminal Block; Terminal Block - Stiebel Eltron CK 15 E Manuel D'utilisation Et D'installation

INSTALLATION

ELECTRICAL CONNECTION

f Secure the appliance with the bottom bracket and one screw
against unintentional unhooking. To do so, hook the bottom
bracket from the back into the rear panel.
13. Electrical connection
DANGER Electrocution
Carry out all electrical connection and installation work
in accordance with relevant regulations.
Damage to the appliance and the environment
!
- Observe the type plate. The specified voltage must
match the mains voltage.
Never install the appliance directly below an outlet.
In case of ROMEX wire, install ½" ROMEX connector in knockout.
In case of Greenfield, please use ½" Greenfield connector.

13.1 Removing the front cover

Remove the two screws at the bottom of the unit. Once removed,
the front face can be removed by pulling it towards you.
1 Screw locations for removing cover

13.2 Routing wire to the terminal block

There is a hole for cable entry in the back of the unit. Install a
cable clamp to prevent the power cable from being pulled out of
the terminal block during operation.
1
1 Cable entry
6 | CK 15-20 E / CKT 15-20 E
1

13.3 Terminal block

Route the power cable through the cable entry hole and into the
terminal block. The ground wire screw is located above the ter-
minal block.
1
1 Terminal block
Consult the chart below for the recommended torque amounts on
the terminal block screws.
Screw Size (mm) Min. Torque (N•cm)
M3.5 60-80
Using the proper torque specifications to secure wire to the wiring
block helps to avoid personal loss or property damage.

14. Appliance handover

Explain the functions of the appliance to the user. Draw special
attention to the safety information. Hand the operating and instal-
lation instructions to the user.
Min. Torque (lbf•in)
5.31-7.08
WWW.STIEBEL-ELTRON-USA.COM