Starting Heating; Adjusting The Time Switch; Stopping Heating / Frost Protection; Cleaning, Care And Maintenance - Stiebel Eltron CK 15 E Manuel D'utilisation Et D'installation

OPERATION

CLEANINg, CARE AND MAINTENANCE

6.1

Starting heating

The temperature is infinitely adjustable. The appliance stops heat-
ing as soon as the selected room temperature has been reached.
f Turn the temperature selector clockwise to the required
setting.
6.2

Adjusting the time switch

With the time switch, the appliance heats with full output and
without temperature control.
f Turn the Timer clockwise to set any number of minutes to
count down from 0 - 60 minutes.
6.3

Stopping heating / frost protection

This position ensures frost protection. The heater starts automati-
cally if the room temperature drops below the frost protection
temperature.
f Turn the temperature selector fully counter clockwise and
ensure that the time switch is set to "0".
7. Cleaning, care and maintenance
The appliance contains no user serviceable parts.
Clean the appliance when cold with ordinary cleaning products.
Avoid abrasive or corrosive cleaning products.
If a pale brownish discoloration appears on the appliance casing,
wipe this off as soon as possible with a damp cloth.
Damage to the appliance and the environment
!
Never spray cleaning spray into the air slot.
8.

Storage

f When not in use, keep the appliance in a dry place.
9.

Troubleshooting

If the appliance does not heat, check the temperature set at the
appliance and the circuit breacker.
The appliance has a safety high limit that shuts the appliance down
if it overheats. After the cause has been removed (for example air
outlet or inlet apertures covered) and the appliance has cooled
down for a few minutes, operation starts again.
If you cannot remedy the fault, notify the contractor who installed
the appliance. To facilitate and speed up your enquiry, please pro-
vide the serial number from the type plate (000000-0000-000000).
WWW.STIEBEL-ELTRON-USA.COM

INSTALLATION

10. Safety

Only licensed electricians should carry out the maintenance and
repair of this appliance.

10.1 General safety information

We guarantee trouble-free operation and operational reliability
only if the original accessories and spare parts intended for the
appliance are used.

10.2 Instructions, standards and regulations

Note
Observe all applicable national and local regulations and
instructions.

11. Appliance description

This appliance is a wall mounted electric heater. It is particularly
suitable for heating rooms, such as work rooms, kitchens, bath-
rooms, wash rooms etc.

11.1 Standard delivery

- Wall mount bracket
- Bottom bracket
12. Installation
DANGER Electrocution
- If installing the appliance in rooms with a bath and/
or shower, take the relevant safety zone into ac-
count in accordance with the information on the ap-
pliance type plate.
- Install the appliance in such a way that switching
and control equipment cannot be touched by a per-
son in the bath or shower.
DANGER Fire
- Only fit the appliance to a vertical wall that is heat-
resistant to at least 194 °F (90 °C).
- Maintain minimum clearances to adjacent surfaces.
- Never install the appliance directly below a wall
socket.
f Check the hole distances for the wall mounting bracket in the
dimensioned drawing.
f Secure the wall mounting bracket with suitable fasteners.
The horizontal and vertical slots in the wall mounting bracket
enable alignment if drilled holes are not completely accurate.
f Hook in the appliance so that both top protrusions are in-
serted into the slots in the wall mounting bracket.
CK 15-20 E / CKT 15-20 E| 5