Starting The Petrol Engine; Starting The Lpg Engine; Starting The Diesel Engine - Nilfisk Retriever 6250 Mode D'emploi

A-12 / ENGLISH

STARTING THE PETROL ENGINE

1 With the Engine Speed Switch (42) in the IDLE position ( l ), turn the Ignition Key Switch (52) clockwise to the START position and release it
as soon as the engine starts. If the engine does not start after cranking for 15 seconds, release the key, wait for 1 minute, then try again.
2 Once started, let the engine run with the Throttle Control Switch in the IDLE ( l ) position for 5 minutes before using the machine.
3 Push the Throttle Control Switch to the FULL THROTTLE position ( lll )and move the machine around for 2 or 3 minutes at a slow speed to
warm up the hydraulic system.

STARTING THE LPG ENGINE

1 Open the service valve on the LPG fuel tank (23).
2 With the Engine Speed Switch (42) in the IDLE position ( l ), turn the Ignition Key Switch (52) clockwise to the START position and release it
as soon as the engine starts. If the engine does not start after cranking for 15 seconds, release the key, wait for 1 minute, then try again.
3 Once started, let the engine run with the Throttle Control Switch in the IDLE position ( l ) for 5 minutes before using the machine.
4 Push the Throttle Control Switch to the FULL THROTTLE position ( lll ) and move the machine around for 2 or 3 minutes at a slow speed to
warm up the hydraulic system.

STARTING THE DIESEL ENGINE

1 With the Throttle Control (60) in the IDLE position, turn the Ignition Key Switch (52) counterclockwise to the GLOWPLUG position and hold until
the Glow Plug Indicator Light (59) turns OFF. Then turn clockwise to the START position and release it as soon as the engine starts.
2 Once started, let the engine run with the Throttle Control in the IDLE position for 5 minutes before using the machine.
3 Push the Throttle Control to the FULL THROTTLE position and move the machine around for 2 or 3 minutes at a slow speed to warm up the
hydraulic system.
NOTE: ALWAYS operate the machine with the Throttle Control at full throttle. Use the Forward/Reverse Pedal (16) - not the Throttle
Control - to control the speed of the machine. The speed of the machine will increase as the pedal is pushed closer to the floor. Do not press the
Forward/Reverse Pedal until the engine has started, this will disengage the starter.
A-12 - FORM NO. 56041573 - Retriever 6250 / SR 1800H
™