Epson ELPIF02 Mode D'emploi page 8

* Tighten the xing screws evenly to
prevent the interface board from
tilting.
Removing
中
文
简
体
中
文
繁
體
8
Tighten the xing screws (4 points) with a
C
commercially available No. 2 cross-head
screwdriver.
Tighten the xing screws securely. If the in-
•
terface board is not xed securely in place,
the projector may malfunction.
• Do not use an electric screwdriver when
tightening the xing screws. Doing so
could damage the interface board.
Loosen the xing screws (4 points) with a
A
commercially available No. 2 cross-head
screwdriver.
Grip the knob, and pull the interface board
B
straight out.
Make sure the slot cover or an interface
board is always installed in the slot. If dust or
trash enters the projector, it could cause a
malfunction.
Caution
Caution