Resetting The Lean Controller; Resetting The Measurement System (Null Pic) - Nussbaum POWER LIFT HL 2.60 SST DG Manuel D'exploitation

6.3 Resetting the lean controller

Access to the DIP switch may only be done by a trained, authorised specialist.

6.3.1 Resetting the measurement system (null PIC)

a) •
Switch off main switch.
b) •
Open the control cabinet Caution voltage!!!
c) Push the null PIC button (keep pushed), switch on main switch. Then release the Null PIC
button within 2 seconds.
Operating Manual and Inspection Book
POWER LIFT HL 2.60 SST DG
- 24 -
Null PIC button