Accessories; Troubleshooting - RIDGID R4520 Manuel D'utilisation

ACCESSORIES

Look for these accessories where you purchased this product or call 1-866-539-1710:
 Dado Throat Plate ........................................................................................................................................089240038701
 Flip Top Portable Work Support .............................................................................................................................AC9934
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments
or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not
recommended can result in serious personal injury.

TROUBLESHOOTING

Problem
Excess vibration.
Rip fence does not move smoothly.
Rip fence does not lock at rear.
Cutting binds or burns work.
Workpiece edges away from rip fence
when ripping.
Cause
Blade is out of balance.
Blade is damaged.
Saw is not mounted securely.
Work surface is uneven.
Blade is warped.
Rip fence not mounted correctly.
Rails are dirty or sticky.
Clamp screw is out of adjustment.
Clamp screw is out of adjustment.
Blade is dull.
Blade is heeling.
Work is fed too fast.
Rip fence is misaligned.
Riving Knife is out of alignment.
Workpiece is warped.
Rip fence is misaligned.
57 - English
Solution
Replace blade.
Replace blade.
Tighten all hardware.
Reposition on flat surface.
Replace blade.
Remount the rip fence.
Clean and wax rails.
Adjust clamp screw.
Adjust clamp screw.
Replace or sharpen blade.
See Adjusting the Blade Parallel to
the Miter Gauge Groove (Removing
Heel) in the Operation section.
Slow the feed rate.
Align the rip fence.
See To check and align the riving knife
and saw blade in the Assembly section.
Replace the workpiece. Always cut with
convex side to table surface.
Check and adjust the rip fence.