RIDGID R4520 Manuel D'utilisation page 26

ASSEMBLY
ASSEMBLING THE RAILS
See Figures 29 - 31.
To assemble the front rail:
NOTE: Do not completely tighten set screws until all front
rail pieces are assembled and you have made sure the rail
will lie flat and level.
NOTE: Front rail sections have a rip scale printed on them.
 Insert half of each rail connector bar into the grooves in
the long rail section.
 Using the 3 mm hex key, secure the connector bars to
the rail by partially tightening the set screws.
 Slide the short front rail section over the attached rail
connector bars. Partially tighten set screws.
 Place the assembled rail sections on a flat surface and
make sure the rail lies flat and level. There should be no
gaps between the two sections.
 Securely tighten all set screws.
To assemble the rear rail:
 Slide the remaining rail connector bar into the slot in the
a rear rail section.
 Assemble the rear rail sections in the same way as the
front rail. Make sure the rail lies flat and level and there
are no gaps between the two sections.
 Securely tighten all set screws.
RAIL
CONNECTOR BAR
SET SCREWS
HEX KEY
FRONT RAIL
SECTIONS
SHORT RAIL SECTION
REAR RAIL
SECTIONS
26 - English
FRONT RAIL ASSEMBLY
RIP SCALE
RAIL
CONNECTOR BAR
CONNECTOR BAR
REAR RAIL ASSEMBLY
RAIL
CONNECTOR BAR
LONG RAIL
SECTION
Fig. 29
RAIL
Fig. 30
Fig. 31