Table - Atag HI4071M Notice D'utilisation

TROUBLESHOOTING
Symptom
Text appears in the displays when the
appliance is first connected.
The fan runs on for several minutes
after the hob has been switched off.
A slight smell is noticeable the first
few times the hob is used.
You can hear a ticking sound in your
hob.
The pans make a noise while cooking.
You have switched a cooking zone on
but the display keeps flashing.
The hob is not working and nothing
appears in the display.
A fuse blows as soon as the hob is
switched on.
Faultcode 1E03; 1E09.
Other faultcodes.
Faultcode 1E01; 2E01; 3E01; 4E01
Faultcode 1E10
Continuous bleep.
Faultcode F11; F42.
Faultcode F99
Possible cause
This is the standard set-up routine.
The hob is cooling.
The new appliance heating up.
Ticking can also occur at lower set-
tings.
This is caused by the energy flowing
from the hob to the saucepan.
The pan you are using is not suitable
for induction cooking or has a diame-
ter of less than 12 cm.
There is no power supply due to a
defective cable or a faulty connection.
The hob has been wrongly connected..
The hob has been wrongly connected
or the mains voltage is too low.
Defective generator.
The hob has overheated.
The hob has been wrongly connected
or the mains voltage is too high.
The hob has been wrongly connected
or the main voltage is too high.
A control has been held for too long.
You pressed two buttons at once.
16

table

Solution
Normal operation.
Normal operation.
This is normal and will disappear once
it has been used a few times. Ventilate
the kitchen.
Normal operation.
At high settings this is perfectly nor-
mal for some pans. It will not damage
either the pans or the hob.
Use a suitable pan, see page 12.
Check the fuses or the electric switch
(if there is no plug).
Check the electrical connections.
Check the connection. Contact your
electricity supplier if the problem con-
tinues
Contact the service department.
The hob has been switched off due to
overheating. Let the hob cool down
and then use a lower setting.
Have the connection changed.
Contact the service department.
Have the connection changed.
Do not hold the control knobs full left
or full right for to long. If the fault-
code is still displayed, contact the ser-
vice department.
Press 1 button at a time.