Installing The Seesnake Centering Guides - Ridgid Kollmann SeeSnake KD-200 Consignes De Sécurité

Kollmann
2. Remove the centering guide, and then slide the c-rings
off the cable. Be sure to open the c-rings far enough
to avoid "scarring" the cable. An alternative method is
to slide the c-rings over the camera head.
Installing the SeeSnake Centering
Guides
The SeeSnake snap-on pipe guide consists of the fol-
lowing parts (Figure 28):
• 1 ball guide
• 1 top sleeve (with alignment pins)
• 1 bottom sleeve (with alignment slots)
Figure 28
Installation
1. Place the ball guide over the SeeSnake camera
spring with the orientation arrow heads pointing toward
the camera (Figure 29 and Figure 30).
Point Arrows
Toward Camera
Figure 29
Standard and Mini SeeSnake Diagnostic Equipment
Ridge Tool Company
Figure 30
2. Place the sleeves over the spring between the ball
guide and camera head with the locking tabs pointed
toward the guide ball (Figure 31).
Alignment Pins
Figure 31
3. Slide ball guide over the sleeves until the locking
tabs engage with the rear of the ball guide (Figure 32).
Figure 32
Orientation Arrows
Locking Tabs
Locking Tab
17