Never immerse the main unit and connecting cable in water or
■
other liquids and ensure that they cannot fall into water or be-
come wet. There is a danger of electric shock from water.
The device must always be disconnected from the mains power
■
when it is left unattended and before transporting, assembling,
disassembling and cleaning the device.
Do not make any modifi cations to the device. Also do not replace
■
the connecting cable yourself. If the device, the connecting ca-
ble or the accessories of the device are damaged, they must be
replaced by the manufacturer, customer service department or
a specialist workshop in order to avoid any hazards.
The device is not designed to be operated with an external timer
■
or a separate remote control system.
Note the cleaning instructions in the "Cleaning" chapter!
■
DANGER – Risk of Electric Shock
■
Use and store the device only in closed rooms. Do not operate the device in rooms
with high humidity.
■
Should the main unit fall into water, cut off the power supply immediately. Do not
attempt to pull the device out of the water while it is still connected to the mains
power! Have the device checked in a specialist workshop before using it again.
■
Never touch the device or the connecting cable with wet hands when these
components are connected to the mains power.
WARNING – Danger of Fire
■
Do not use the device in rooms containing easily ignitable or explosive substances.
■
Do not operate the device in the vicinity of combustible material. Do not place any
combustible materials (e.g. cardboard, paper or plastic) on or in the device.
■
Do not connect the device along with other consumers (with a high wattage) to a mul-
tiple socket in order to prevent overloading and a possible short circuit (fi re).
■
Do not insert anything into the ventilation openings of the device and make sure that
these do not become clogged.
■
In the event of a fi re: Do not extinguish with water! Smother the fl ames with a fi re
blanket or a suitable fi re extinguisher.
NOTICE – Risk of Damage to Material and Property
■
The device should only be connected to a properly installed socket with safety con-
tacts. The socket must be readily accessible so that the connection to the mains can
quickly be isolated. The mains voltage must match the technical data of the device.
■
Do not use any extension cables.
■
Unwind the mains cable fully before connecting up the device.
19
EN