Numatic NV-450 Mode D'emploi page 9

WARNING
Read the instruction manual before using the machine.
Operators shall be adequately instructed on the use of their machine.
As with all electrical equipment, care and attention must be exercised at all times during use, in addition to ensuring that
routine and preventative maintenance is carried out periodically to ensure safe operation.
Failure to carry out maintenance as necessary, including the replacement of parts to the correct standard could render
this equipment unsafe and the manufacturer can accept no responsibility in this respect.
Maintenance should only be carried out by a qualifi ed person.
This machine is for DRY USE only and must not be stored outside or used in wet conditions.
The machine shall be disconnected from the mains power by removing the plug from the power supply socket during
cleaning or maintenance and when replacing parts or converting the machine to another function.
Only use the socket outlet on the machine for purposes specifi ed in the instructions (if fi tted).
This machine is not to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of
experience or knowledge.
This appliance is intended to be cleaned and maintained by an adult.
Children being supervised are not to play with the machine.
This machine is not a toy.
This machine is not suitable for picking up hazardous or explosive dust.
Contact your local distributor if you require a machine capable of performing these tasks.
CAUTION
Ensure that the fi ltration system fi tted to the machine is suitable for the material being collected.
This vacuum cleaner is intended for indoor use in the collection of dry materials.
This machine should be stored indoors only.
NOTES
The primary use for this machine is commercial, for example in hotels, schools, hospitals, factories, shops and offi ces.
This product complies with the requirements of clause 20 of IEC/EN 60335-2-69 Stability and Mechanical Hazards.
This vacuum cleaner is fi tted with a thermal protection device. If the vacuum cleaner stops working, remove the plug
from the wall before investigating where the fault lies.
If the vacuum cleaner has a blockage, switch off , remove the plug from the power socket, inspect the fl oor tool, tubes
and hose for debris. If the fl oor tool, tubes and hose are clear, replace the dust bag and clean the fi lter.
The vacuum cleaner should be inspected after use for damage.
The vacuum cleaner should be stored in a dry place.
When moving from one place to another, consider the weight of the machine.
DO
• Keep your machine clean including hoses and tubes.
• Change dust bag frequently.
• Keep fi lters clean.
• Keep diff user fi lter (where fi tted) clean.
• Use fi lter bags, they will enhance performance and help keep machine clean.
• Use a Numatic Original fi lter bag under fi ne dust conditions.
• Keep hoses and tubes clear.
• Replace any worn or damaged parts immediately.
• Only use the brushes provided with the machine. The use of other brushes may impair safety.
• Regularly examine the power cord. If damage is found such as cracking or ageing the power cord must be
replaced by a qualifi ed person.
• Only replace the power cord with the correct Numatic approved replacement part.
DO NOT
• Pull on the cable to unplug the machine from the power supply.
• Use to suck up hot ashes or lighted cigarette ends.
• Use steam cleaners or pressure washers to clean the machine or use in the rain.
• Immerse in water for cleaning.
• Attempt machine maintenance or cleaning unless the power supply plug has been removed from the supply outlet.
• Use in wet environments or to collect wet materials.
• Under any circumstances place foreign objects including (but not limited to) air fresheners, air freshener capsules
or scented beads of any type into the top fi lter of the machine. Doing so can be dangerous and risk damage to the
machine and may invalidate the machine warranty.
Information for DRY use Vacuum cleaners