Hornbach 6746179 Mode D'emploi page 10

English
I.
1
2
2
3
II.
1. 2. 3.
GB
Please read these instructions
Assembly instructions
carefully and keep them safe for
later use!
I.
Description
1 Luminaire 6746177 (60 cm) Safety information
• Electrical work and repairs must be
2 Connection cable performed by a qualified electrician.
4 • During installation, always observe
3 Luminaire 6746179 (30 cm) the national installation regulations.
• The luminaire must not be modified
4 4x Screws in any way. Risk of electric shock
and accident.
5 2x Mounting bracket
5
Technical data
Nominal voltage
Rated power:
6746179
6746177
II.
Assembly
Protection class:
Luminaires described in this man- Degree of protection: IP20
ual are extensions for luminaires Operation temperature: -20 °C - +40 °C
6746180 and 6746178 Humidity:
Colour temperature: 3000-3300 K
1. Select an installation location at your Light Source:
cabinet. Make sure that the distance
between the luminaires can be cov- Weight:
ered by the connection cable 2. 6746179
Mark the holes of the mount- 6746177
ing brackets 5 with the required Size:
distance and drill the holes (see 6746179
technical data). Make sure that the 6746177
brackets 5 are on the same level. Luminous flux:
2. Fix the brackets 5 in place with the 6746179
screws. 6746177
3. Clip the luminaire into the brackets 5. Hole distance of single
mounting bracket:
6746179
6746177
18
ENGLISH ENGLISH
III.
• The light source of this luminaire
is not replaceable; when the light
source reaches its end of life the Connect the luminaires with the connec-
whole luminaire shall be replaced. tion cable 2:
• Only use the provided connection
cable. If the connection cable is A. 6746179 (30 cm)
damaged, it shall be replaced by
a special connection cable or a
connection cable exclusively avail-
able from the manufacturer or his B. 6746177 (60 cm)
service agent.
IV.
Waste disposal
12 V The pictogram with the crossed A. Switching on/ off
out dustbin points to the require-
5W ment for separate disposal of
9.6 W electrical and electronic appliances B. Adjusting the brightness
(WEEE). Electrical and electronic ap-
III pliances can contain hazardous and
environmentally hazardous materials.
Do not dispose of this appliance as
10-80% domestic waste. Hand it in at a collec-
tion point for electrical and electronic
LED – non- waste. By doing so, you will help to
replaceable! conserve resources and protect the
environment. For further details,
115 g please consult your dealer or your lo-
200 g cal authorities.
V.
300x40x10.5 mm
600x40x10.5 mm
Used symbols
430 lm Caution: Risk to health and the
900 lm product.
Do not use outdoors or in damp
20 mm environments.
20 mm
Protection class II
GB
Connection
A.
30 cm
Extension for luminaire
6746180 (30 cm)
B.
60 cm
Extension for luminaire
6746178 (60 cm)
Caution: A driver can run max. 1
luminaire and 1 extension at the
same time.
Usage
Turn on and off with a swiping ges-
A.
ture over the sensor button.
Let your hand stay over the sensor
button for more than 1 second. The
brightness of the luminaire will in-
crease.
B.
Move your hand away and again
let it stay over the sensor button.
The brightness of the luminaire will
decrease. The brightness setting is
saved until a new setting is set.
Maintenance and care
Caution: The light source is not
replaceable.
Cleaning
1. Disconnect the power supply
cord from the power outlet.
2. Wipe the luminaire with a
soft, dry cloth only. Never use
scouring powders or chemical
cleaning agents. Never allow
the electrical components to
become damp.
19
III.
30 cm
60 cm
IV.
> 1s 2.
1. > 1s
V.