Anchor Outdoor Unit; Air Outlet - MrCool DIY Série Manuel D'installation

W
Air Inlet
D
Outdoor Unit Dimensions (inches)
Width (W) x Height (H) x Depth (D)
30.7 x 21.25 x 9.85 (inches)
DIY-12-HP-C-115A
31.9 x 22 x 12.2 (inches)
DIY-18-HP-C-230A
33.25 x 27.5 x 12.6 (inches)
DIY-24-HP-C-230A
37.2 x 31.9 x 15.55 (inches)
DIY-36-HP-C-230A
If you will install the unit on the ground or
on a concrete mounting platform, do the
following:
1. Mark the positions for four expansion bolts
based on dimensions in the Unit Mounting
Dimensions chart.
2. Pre-drill holes for expansion bolts.
3. Clean concrete dust away from holes.
4. Place a nut on the end of each expansion bolt.
5. Hammer expansion bolts into the pre-drilled
holes.
Page 21
H
Fig. 4.5
For more details visit www.MrCool.com
Step 3: Anchor outdoor unit
The outdoor unit can be anchored to the ground
or to a wall-mounted bracket.
UNIT MOUNTING DIMENSIONS
sizes and the distance between their mounting
feet. Prepare the installation base of the unit
according to the dimensions below.
Air Inlet

Air Outlet

Mounting Dimensions (inches)
Width (A)
21.6 in.
21.6 in.
22 in.
25.2 in.
6. Remove the nuts from expansion bolts, and
place outdoor unit on bolts.
7. Put washer on each expansion bolt, then
replace the nuts.
8. Using a wrench, tighten each nut until snug.
WARNING
WHEN DRILLING INTO CONCRETE, EYE
PROTECTION IS RECOMMENDED AT ALL
TIMES.
B
Depth (B)
10.85 in.
12.8 in.
13.2 in.
15.95 in.