TP-Link EAP225 Guide D'installation page 12

English
4
Attach the EAP/CAP to the mounting bracket by
aligning arrow (on the EAP/CAP) with arrow (on
the mounting bracket), then rotate the EAP/CAP
clockwise until it locks into place.
5
Connect the Ethernet cable to the ETHERNET
port.
Option2 ： Ceiling Mounting
■
Follow the steps below to install the EAP/CAP with the provided accessories:
Washers
(Qty.3)
1
Remove the ceiling tile.
2
Place the mounting bracket in the center
of the ceiling tile. Mark the three positions
of the screw holes and a 10mm hole for
the Ethernet cable to feed through. Drill
three 4mm holes and a 10mm hole for the
Ethernet cable.
9
M3×30 Pan-head Screws
(Qty.3)
Wing Nuts
(Qty.3)
Hole for Ethernet cable
X3