General Instructions For Use; Maintenance And Service Instructions; Cleaning; Repair Service - stayer SD27BE Instructions D'emploi

To switch off the power tool, release the On/Off switch 5 or,
if it is locked, briefly push down the back of the On/Off
switch 5 and then release it.
Kickback stop
In case of a sudden drop in speed, e.g., caused by a
jammed disc while cutting, the power supply to the motor is
electronically interrupted.
To restart the operation, switch the On/Off switch 5 to the
Off position and start the machine again.
Constant Electronic Control
Constant electronic control holds the speed constant at
noload and under load, and ensures uniform working
performance.
Speed preselection
The required speed can be preselected with the
thumbwheel 6 (also while running).
The required speed depends on the material being worked
and the diameter of the application tool. Observe the
maximal allowable speed of the application tool.
Thumbwheel
Position
1
2
3
4
5
6

4.2 General instructions for use

Optimum grinding results are achieved when the grinding
tool is moved uniformly back and forth with light pressure.
Pressure that is too strong reduces the performance
capability of the machine and causes the grinding tool to
wear more quickly.

5. Maintenance and service instructions

Before any work on the machine itself, pull the mains
plug.
For safe and proper working, always keep the machine
and ventilation slots clean.

5.1 Cleaning

In extreme conditions, always use dust extraction as
far as possible. Blow out ventilation slots frequently
and install a residual current device. When working
metals, conductive dust can settle in the interior of the
power tool. The total insulation of the power tool can be
impaired.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should be
carried out by an after-sales service centre for STAYER
power tools.

5.2 Repair service

Our after-sales service responds to your questions
concerning maintenance and repair of your product as well
as spare parts.
No load speed
10000 2500
12700 3600
16700 4600
19700 5700
23500 6800
28000 7000
ENGLISH
18
Exploded views and information on spare parts can also be
found under:
info@grupostayer.com
Our customer consultants answer your questions
concerning best buy, application and adjustment of
products and accessories.

5.3 Warranty

Warranty card
accompanies this equipment, you should find the warranty
card. You should fill out the card completely and return to
vendor with a copy of purchasing receipt or invoice and you
should receive a receipt.
Note: If you cannot find the warranty card within the
documentation, you must ask for it through your supplier.
The warranty is limited only to manufacturing defects and
expire if pieces have been removed or manipulated or
repaired other than the manufacturer.

5.4 Disposal and recycling

The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household waste!
According the European Guideline 2002/96/EC
for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
s e p a r a t e l y a n d d i s p o s e d o f i n a n
environmentally correct manner.
Subject to change without notice.

6. Regulations

6.1 Technical Data

P = Rated power input
1
R = Load speed
1
Dmax = Wheel diameter, max.
Pz = Pin
= weight
kg
= Protection class
L = Sound power level
WA
L = Sound pressure level
A
P
= Vibration
The values given are valid for nominal voltages [U] 230/240 V ~
50/60 Hz - 110/120 V ~ 60Hz. For lower voltage and models for
specific countries, these values can vary. Please observe the
article number on the type plate of your machine. The trade
names of the individual machines may vary.
18
Included in the documentation that