Makita SKR60 Mode D'emploi page 7

The laser can also be fastened to the wall with nails,
using the 2 holes in the wall mount plate.
Setup on a Tripod
There are two standard 5/8-11 tripod mounts: one on
the bottom of the laser for horizontal mode, the other
on the wall mount for vertical mode.
A camera tripod mount is located on the other side
of the wall mount for both horizontal and vertical
modes.
After attaching the laser to the tripod, be sure to
level the bubbles as described on page 4.
Changing mounts:
1) To switch from the 5/8-11 to camera tripod mount,
take out the wall mount plate by opening the height
adjustment clamp (9) and pressing the wall mount
release (14).
2) Rotate the plate, slide it back into the wall mount,
and lock the clamp (9).
Using the laser in horizontal mode on tripod:
1) Use the tripod mount (16) to attach the laser to the
tripod.
2) To position the laser so that the rotating beam is
horizontal, open the adjustable slope lock (15). Tilt
the laser 90 (the full extent you can move it).
3) Level the bubble as described under "Horizontal
Setup."
7