Installation - Opus Technologies OP-10SRX Manuel D'installation Et D'utilisation

OP-10SRX | Manuel d'installation et d'utilisation | Installation and user manual |
15

3. Installation

(1) Power output connector
Plug in one end of AC/DC adaptor cable to DC input socket in the rear panel of receiver, and
plug another end into an AC outlet.
(2) Audio output connector
Connect one end of the AF output cable to the AF output socket in the rear pannel, then plug
another end to the « MIC IN » input socket of a mixer or amplifier.
TG-10SRX equipped with balanced XLR output and unbalanced ᴓ6.3mm output, choose the
proper way for use.
(3) LED panel
1 : AF signal
2 : RF signal
3 : Channel Display
4 : Diversity Display
(A or B antenna)
(4) Setting the rubber pad
Four self-adhesive rubber pads are provided to ensure the stabili-
ty.
They are to be placed on the bottom of the receiver.