Operating Accessory Tools (Optional) - Tennant 1510 Manuel De L'opérateur

OPERATION

OPERATING ACCESSORY TOOLS (OPTIONAL)

The optional accessory tools allow you to clean
upholstery and areas that the machine is unable to
clean, such as alcoves, stairs, corners and small
rooms.
For a complete list of accessory tools see the
OPTIONS section in this manual.
NOTE: When cleaning upholstery, always check
cleaning instructions sewn in the furniture by
manufacturer.
1. Turn the key to the OFF position.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.
WARNING: Do Not Use Flammable Liquids Or
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
2. Connect the accessory tool's solution hose to the
quick disconnect coupler located at the rear of the
machine (Figure 14).
FIG. 14
3. Disconnect the lower vacuum hose from the
machine and replace it with the accessory's tool
vacuum hose (Figure 15).
FIG. 15
4. Turn the key to the ON position.
12
5. Position the cleaning function switch towards the
vacuum symbol and the cleaning mode switch
towards the deep clean mode symbol (Figure 16).
FIG. 16
6. Place the accessory tool on the area to be
cleaned. Squeeze the trigger on the accessory
tool and slowly pull the tool backwards while
applying downward pressure (Figure 17). Release
the trigger 6 inches from end of stroke. When
returning to the next stroke, push the tool forward
over the same path with trigger released. Continue
this pull and push method with a 2- 4 inch overlap.
WARNING: Do Not Pick Up Flammable
Materials Or Reactive Metals.
FIG. 17
7. After cleaning, relieve the water pressure from the
accessory tool before disconnecting the solution
hose. Squeeze trigger for five seconds after
turning the key off.
Tennant 1510 (12- 02)