Friedrich Hazardgard Manuel D'installation Et D'utilisation page 15

Shell (Cabinet) Preparation for Installation
STEP 1 Remove still plate and bend the taps up and reinstall. See (DETAIL 16-A).
STEP 2 Take the side angles (item #6) and engage its loops in the tabs (both sides) of the sill plate. (DETAIL 16-A).
STEP 3 Take the top Flange (item #5) and engage its tabs in the top loops of the side flanges (DETAIL 16-B).
STEP 4 Install two (2) screws (Item #7) to secure the top angle tabs and the side angle in the side of the cabinet (Detail 16-B).
Figure 16
CABNET
TOP ANGLE (ITEM #5)
TAB
A
D E T A IL 16 - B
SIDE ANGLE (ITEM #6) 8-A X 3/8" LONG SCREW
2 REQUIRED (ITEM #7) 2 REQUIRED
B
LOOP
SILL PLATE TAB
D E T A IL 16 - A
TAB
15