CASCO PF 112 Instructions page 16

AFFIXING THE VISOR
AFFIXING HOLLAND CLOTH
ALL-ROUND PROTECTION
This is achieved using the six snaps along the inner
edge of the helmet inner shell and temple area by
means of the pins along the interior construction.
MOUNTING THE FLASHLIGHT
A torch holder can optionally be fixed to the helmet
adaptor (right and/or left) (Fig. 10).
TRANSMISSION FACTOR TO DIN EN 14458:2004
As can be seen from this illustration, the protection against radiated heat offered by this visor is dependant
on the temperature of the heat source. The visor should only be used in those situations where it can
reduce exposure of the wearer's eyes to less than 100 W/m².
Transmission factor 75% at 2400 K source temperature
100
90
80
70
60
50
40
30
20
10
500
16
Fig. 8
Fig. 10
1000 1500
Place the helmet upside
down and put the visor
into the adapters on the
left and right side of the
helmet. (see Fig. 7). To
remove the helmet, press
the latching button on
the mounting and pull the
visor holder out.
Fig. 7
AFFIXING NECK PROTECTOR
Fig. 9
USE OF RESPIRATORY MASK
Please note that the interior construction is per-
fectly suited for use with a respiratory mask. There
is no need to order this separately. The angled form
of the head band allows the respiratory mask an
optimum fit within the helmet (Fig. 11).
Transmission factor 9% at 586 K source temperature
2000 2500
This is done by means
of the six press studs
along the helmet inner
shell. (Fig. 9, (see also
Fig. 2/13)).
Fig. 11
Transmission factor,
low temperature
Transmission factor,
high temperature