Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Always use the appliance on a flat, steady surface that is able to support its weight.
Always unplug the machine from the power supply before performing any cleaning or
maintenance operations.
Do not use jets of water or detergents for cleaning.
In the case of machine breakdown or malfunction switch the machine off and do not tamper with it.
For repairs contact only an authorized service center and request use of original spare parts.
Non-observance of the above precautions may make the machine unsafe for future use.
Do not leave the machine switched on when not in use. Unplug the machine when not in use.
Do not obstruct the ventilation and/or heat dissipation openings and/or slits nor introduce
water or any other liquids into same.
Do not obstruct the ventilation and/or heat dissipation openings and/or slits nor introduce
water or any other liquids into same.
Never insert spoons, forks or other utensils into the pouring lip (11) (see Fig. 1), or into
the coffee grain container (2) (see Fig. 1) for any reason whatsoever while the appliance
is operating.
Always switch off the appliance before removing blockages from the pouring lip.
Never place the appliance in water or other liquids.
Should a foreign body stop the motor, switch the machine off immediately and contact an
authorized service center.
Should a foreign body stop the motor, switch the machine off immediately and contact an
authorized service center.
WARNING
If the thermal breaker to protect the motor is triggered, do not attempt any other
manoeuvre. Unplug the machine from the power mains and make sure that any prob-
lems have been solved before switching the machine on again.
7.
INSTRUCTIONS FOR USE
7.1
PREMISE
This machine is capable of producing very precise doses, since it bases itself on the time of
the grind. It is however necessary to fine tune the machine before starting to work, above
all deciding the blend of coffee (lighter or darker roast) and the grade of grind. You then
proceed to programming the time of grind for each dosage, weighing the ground product.
Carry out the electrical connections during the installation process.
After connecting to the electrical outlet, close the flap (9) (see Fig. 1) at the base of the
whole bean coffee container (2).
Remove the lid (3) from the container (2) and fill with whole bean coffee.
Bring the switch (4) to the "ON" position. The red led on the switch itself will come on.
Open the flap (9).
Place the portafilter bowl on the rods (7) (see Fig. 4) and push it forwards until it comes
into contact with the microswitch (6) to pour out the ground coffee through the nozzle (8)
(see Fig. 5).
WARNING
Keep the portafilter bowl on the rods (7) to prevent the nozzle (8) from becoming
clogged.
MYTHOS
15
Publicité
Table des Matières
