KRONAsteel CELESTA Série Guide De L'utilisateur page 15

EN Application sheet
INSTRUCTIONS ON THE USE
OF THE KITCHEN HOOD
The kitchen hood is to be used for extraction of
smells from the kitchen. It may work in two modes
depending on the method of its installation:
— mode of air removal into the air shaft;
— recirculation mode.
In the mode of air removal into the air shaft (see
Fig. 5), the kitchen hood is connected to the air
shaft with the help of a corrugated hose or a plas-
tic air conduit. Thus, all the evaporations from the
kitchen, smells, char and soot pas through reus-
able aluminum grease trap filters and are removed
outside the premises. With this working mode, it is
not necessary to install charcoal acrylic scent-trap
filters. Extraction mode is the most efficient as the
kitchen hood removes all the evaporations from
the kitchen to the air shaft.
In the recirculation mode (see Fig. 6), the kitch-
en hood is not connected to the air shaft, and thus
the air is just passed through the kitchen hood in-
side the kitchen.
In this mode, charcoal acrylic disposable scent-
trap filters should be installed on the kitchen hood.
These filters are not included in the set and are
bought separately. The use of the kitchen hood in
the recirculation mode reduces its productivity.
We recommend using the kitchen hood in the
mode of air extraction to the air shaft.
MAINTENANCE AND SERVICE
OF THE KITCHEN HOOD
Before starting any cleaning or repair opera-
tion for the hood, turn off the mains voltage.
For external cleaning of painted hoods, use a damp
cloth moistened with warm water with a neutral de-
tergent. For top cleaning of steel, copper and brass
surfaces, use special tools, following the appropri-
KITCHEN HOODS
ate instructions. Never use chlorine-containing
and acid-containing products, abrasive agents or
sponges to clean the extractor, which can scratch
the surface.
Aluminum grease filter, retaining particles of fat
and passing through it the dust from the air, clogs.
It should be cleaned not with acid-containing sub-
stances or washed after preliminary soaking in hot
water with an effective detergent or, if possible, in a
dishwasher (at 65 ° C). Strongly soiled, grease filters
should not be washed in the dishwasher together
with the dishes. Simultaneously with the cleaning
of the grease collector, clean the fat deposits of all
available elements of the hood.
To remove aluminum filters, it is necessary to open
the flip cover (item 3 on figure 1) in the service mode
with the help of the remote control. Pressing on the
lock of the aluminum filter, remove it (Fig. 7).
Do not install the filter in the hood until it dries
completely.
The filter is installed in reverse order. It is necessary
to press the spring lock on the filter and install it in
place, after which the lock is released.
For your hood, two coal filters are installed. They are
mounted on the protective grilles of the motor duct
by lightly pressing and turning them clockwise.
To remove the carbon filter, it should be slightly
squeezed and turned counter-clockwise.
For backlight, on the hood, LED strip is used. The
purchase and replacement of the strip is done by
means of an authorized service center.
Before starting any cleaning or repair operation for
the hood, turn off the mains voltage.
Installation of carbon filters
Replacing the backlight
13