Time Setting; Timer Setting - KRONAsteel CELESTA Série Guide De L'utilisateur

EN Application sheet
4. Lights on/off
5. Remote control signal receiver.
The remote control elements have the following
functions (see Pic, 4a):
1. Motor on/off. Lifting the hinged glass panel and
closing it down.
2. Lifting the hinged glass panel and closing it
down for maintenance service needs (if the
hinged panel is opened using this button, the
motor and lighting functions do not work).
3. Time setting activation
4. Speed up/down
5. Timer activation
6. Lights on/off
7. Protective film. When using the remote control
for the first time, pull the film out softly. This will
activate the pre-installed remote control bat-
tery.
SENSOR TOUCH CONTROL PANEL
FUNCTIONS (see Pic. 4)
When the cooker hood is connected to a power
source, it automatically goes to standby mode, af-
ter that the icon will start glowing.
Touching the icon opens the hinged panel
and turns on the 1st fan speed. If you touch the
icon once again for a short time, it will turn the mo-
tor off, while the hinged panel will remain open,
and the lights will not turn off. If you touch and hold
the , icon for more than 3 sec, the motor and
the lighting will turn off, the hinged panel will close
and the cooker hood will go to standby mode.
The icon increases and reduces the fan
speeds. The switching of the fan speeds is only
available when the hinged panel is opened. This
button does not turn the motor off.
Touch the button to turn on and off the light-
ing of the cooker hood when the hinged panel is
opened. Closing the hinged panel will automati-
cally turn off the lighting.
KITCHEN HOODS
You can set up the current time using the sensor
touch control panel. To set up the time make sure
the cooker hood is turned on, and the hinged panel
is opened. The current time will only be indicated
on the display when the cooker hood is in the op-
eration mode. The time or any other information is
not indicated on the display in standby mode. To
activate the function of time setting touch the two
icons
two digits on the display will start blinking, which
means you can set up the hours value first. Use
the
necessary hour from 0 to 23. To proceed with set-
ting up the minutes value, touch and hold the
icon for not less than 3 sec, and use the
, to set the necessary minutes value from 0 to 59.
To finish the setting and activate the timing func-
tion, touch the two icons
again or wait for 10 sec when the timing function
activates automatically. After that, the cooker
hood will exit the setting mode.
To set up the timer interval make sure the cooker
hood is turned on and the hinged panel is opened.
Touch the two icons
and hold for 1 sec. The time digits on the display
will disappear and you will see zeros blinking in-
stead. You can set up the timer interval from 1 to 60
minutes. Touching the
val by 15 minutes, touching the
the interval by 1 minute. The
the interval by 1 minute.
After the setting is finished, touch the two icons
+
countdown. If the activation is not done after 10
sec, the timer will start the countdown automati-
cally; the digits of the time left will be indicated
on the display. After the interval is over, the motor

TIME SETTING

+ . simultaneously, after that the first
(down) and (up) buttons to set the
+

TIMER SETTING

+
icon increases the inter-
, simultaneously to activate the timer
simultaneously
simultaneously
icon increases
icon decreases
11