What Should I Do If; Environmental Aspects; Disposal Of Packaging And Appliance - Atag OX60E Série Mode D'emploi

faults

what should I do if...

If the appliance does not work properly, this does not always mean that it is defective.
Try to deal with the problem yourself first. Phone the service department if the advice
given below does not help.
fault cause
The clock does not work. No power supply.
Fuse in the meter cupboard
defective.
Oven or grill does not heat up. Fuse in the meter cupboard
defective.
End-time set.
Temperature is not correct. Temperature set incorrectly.
Thermostat defective.
Oven light not on. End-time set.
No power supply.
Bulb defective.
Oven switches off suddenly. Working-time limiter has
switched the oven off.
GB 22
solution
Insert the plug in the socket.
Switch on the two-way and off
switch in the meter cupboard.
Replace the fuse.
Replace the fuse.
The oven switches on
automatically.
Set the oven temperature
again.
Switch oven off and phone the
service department.
The light will come on when
the door is opened and when
the oven switches on.
Insert the plug in the socket.
Switch on the two-way and off
switch in the meter cupboard.
Switch oven off and replace the
bulb. Disconnect the appliance
from the power supply by
removing the plug from the
socket or by turning the two-
way and off switch in the meter
cupboard or by removing the
fuse. You can snap the glass
cover out of the side wall of the
oven. The bulb is then
accessible. Replace it with a
new bulb 230 V-50 Hz-
300 °C/25 W.
Reset the oven.

environmental aspects

disposing of packaging and appliance
The appliance's packaging is recyclable. The following may be
used:
• cardboard;
• polyethylene film (PE);
• CFC-free polystyrene (PS rigid foam).
Dispose of these materials responsibly and in accordance
with government regulations.
The government can also provide information about the
responsible disposal of discarded domestic appliances.
GB 23