Important; Finishing Customer-Provided - Assa Abloy effeff 819 Notice D'installation Et De Montage

A
Pic. 12 :
Measurement for the
finishing of customer-
provided striking plates
EN
54
Finishing customer-provided striking plates
Matching striking plates can be ordered from ASSA ABLOY Sicherheitstechnik Gmbh.
Impor tant!
The control latch may not extend with a closed door. With the completion of the striking plates it
must be ensured that the control latch never extends with a closed door. The door can then no longer be
opened. The control latch is not provided for closing and locking and can therefore not be retracted again.
With the production of a costumer-provided striking plate, the following specifications must be observed:
· The measurements mentioned in Pic. 12 must be observed,
· the latch and control latch must be pushed back by the same striking edge,
· the latch and control latch must be able to slide completely to the closed position unhindered over a
continuous, completely level surface (without drilled holes, depressions or the like),
· limit values for the rebate gap must be observed.
12
11
Limiter range for
control latch
Latch bolt aperture
Dead bolt cutout
Installation