Charging The Battery Pack; English (Uk) - Samsung EB-PJ200 Mode D'emploi

Getting started

Charging the battery pack

Charge the battery before using the battery pack for the first time or when the battery pack
has been unused for extended periods.
Use only Samsung-approved chargers and cables. Unapproved chargers or cables can
cause the battery to explode or damage the battery pack.
1
Connect the battery pack to the USB power adaptor via the USB cable. Plug the USB
power adaptor into an electric socket.
Connecting the charger improperly may cause serious damage to the battery pack.
Any damage caused by misuse is not covered by the warranty.
• Y ou can charge the battery pack using the charger (sold separately).
• T he battery pack can be used while it is charging, but it may take longer to fully
charge the battery.
• W hile charging, the battery pack may heat up. This is normal and should not affect
the battery pack's lifespan or performance. If the battery gets hotter than usual, the
charger may stop charging.
• I f the battery pack is not charging properly, take the battery pack and the charger
to a Samsung Service Centre.
2
After fully charging, unplug the USB cable from the battery pack, and then disconnect it
from the electric socket.
• T o save energy, unplug the charger when not in use. The charger does not have a
power switch, so you must unplug the charger from the electric socket when not in
use to avoid wasting power. The charger should remain close to the electric socket
and easily accessible while charging.
• T he socket-outlet shall be installed near the equipment and shall be easily
accessible.

English (UK)

5
3