Mains Input - Marshall 1962 BLUESBREAKER Manuel Du Propriétaire

5 16
be set to 8 Ohms. If running into two 8
Ohm cabs, the amp should be set to 4
Ohms.
WARNING: Failure to comply with these
points may result in damage to the amplifier.
16. MAINS SELECTOR
WARNING: Your amp should be completely
powered down before the MAINS
SELECTOR is turned.
The MAINS SELECTOR matches the
amplifier to the incoming mains voltage.
Ensure that the mains selector is set to
the correct voltage applicable to the
country where the amplifier is being
used. If you are unsure of the mains input
voltage contact your authorised Marshall
dealer.
WARNING: Failure to comply with these
points may result in damage to the amplifier.

17. MAINS INPUT

Your amp is provided with a detachable
mains (power) lead which connects
here. The specific mains input voltage
rating that your amplifier has been built
for is shown on the rear panel. Before
connecting for the first time, please
17
ensure that your amplifier is compatible
with your electricity supply. If you have
any doubt, please get advice from a
qualified person. Your Marshall dealer
will help in this respect.
18. MAINS FUSE
The correct value of mains fuse is
specified on the rear panel of the
amplifier.
19. H.T. FUSE
The correct value of H.T. fuse is
specified on the rear panel of the
amplifier.
ENGLISH
18 19