Control Panel - Kuppersbusch ITE138-0 Notice D'utilisation

Environment Protection
This appliance does not contain gasses
which could damage the ozone layer, in
either its refrigerant circuit or insulation
materials. The appliance shall not be dis-
carded together with the urban refuse
and rubbish. The insulation foam con-
tains flammable gases: the appliance

Control panel

1 Pilot light
2 ON/OFF switch
3 Temperature regulator (warmest)
4 Temperature indicator
5 Temperature regulator (coldest)
6 Fast Freezing light
7 Fast Freezing switch
8 Alarm light
9 Alarm reset switch
Switching on
Insert the plug into the wall socket.
Press the ON/OFF switch .
The Pilot Light will light up.
Switching off
The freezer is shut off by pressing the ON/
OFF switch until the Pilot light and the Tem-
perature indicator switched off.
Temperature regulation
The temperature can be adjusted between
-15°C and -24°C.
By pressing the Temperature regulators , the
current temperature setting flashes on the
Temperature indicator. It is possible to mod-
ify the setting temperature only with flashed
indicator. To set a warmer temperature,
press warmest Temperature regulator . To
set a colder temperature, press coldest Tem-
perature regulator. The Temperature indica-
tor displays the newly selected temperature
1 2 3 4
shall be disposed according to the ap-
plicable regulations to obtain from your
local authorities. Avoid damaging the
cooling unit, especially at the rear near
the heat exchanger. The materials used
on this appliance marked by the symbol
are recyclable.
5 6 7 8 9
for a few seconds and then shows again the
inside compartment temperature.
The newly selected-temperature must be
reached after 24 hours.
Caution! During the stability period by
the first starting the temperature
displayed can not correspond to the
setting temperature.
Temperature indicator
During normal functioning the Temperature
indicator shows the temperature inside the
freezer.
Important! Difference between the
temperature displayed and temperature
setting is normal. Especially when:
• a new setting has recently been selected.
• the door has been left open for a long time.
• warm food has been placed in the com-
partment.
Fast freezing function
You can activate the Fast freezing function by
pressing the Fast freezing button.
The Fast freezing light will light up.
This function stops automatically after 52
hours.
It is possible to deactivate the function at any
time by pressing the Fast freezing button.
The Fast freezing light will switch off.
13