Used Symbols; Remote Control; Intended Use; Declaration Of Conformity - Hornbach Molveno Mode D'emploi

Used symbols

Please read this user manual carefully
and keep it for further reference.
Caution: Risk to health and the product.
Caution: Risk of electric shock.

Intended Use

This product is designed exclusively for opening
and closing awnings. The product is not intended
for commercial use.
Any other use or modification to the product is
considered as improper use and could cause
considerable dangers.

Declaration of conformity

Hereby, HORNBACH Baumarkt AG declares that
the radio equipment type "tubular motor" is in
compliance with Directive 2014/53/EU and the
Machinery Directive 2006/42/EC.
The full text of the EU declaration of conformity is
available at the following internet address:
www.hornbach.com/productcompliance

Remote control

I. Description
1. Red LED indicator light
2. Button
3. Stop button
4. Light button (only 6196477)
5. Button
6. Battery compartment
7. Setting button P2
II. Pairing with tubular motor
1. Switch on. A long sound can be heard.
2. Press setting button P2 twice with a thin
pointed tool. Two short sounds can be heard.
3. The arrow button, you press next, will be as-
signed to extending the awning:
a. If you press after the sounds,
tract the awning from now on, or
b. If you press
after the sounds,
tract the awning from now on .
Setting up remote control deletes all older set-
tings. Press buttons within an interval of less
than 10 sec., otherwise the settings will return to
original status.
III. Inserting/changing battery
Slide open the battery compartment on the back
of the remote control. Place the delivered 3 V
CR2430 battery with + (plus pole) facing up-
wards into the battery compartment and close it
again.
(Right foldout page)
will ex-
will ex-
EN 37