Safety Instructions - Hornbach Molveno Mode D'emploi

Safety instructions

Please read these instructions carefully before
using the product, follow them thoroughly and
keep them for future use. Not following them can
lead to serious injury.
• Electrical work and repairs must be per-
formed by a qualified electrician.
• During installation, always observe the na-
tional installation regulations.
• The product must not be modified in any way.
Risk of electric shock and accident.
• The installation and repairing of the product
shall only be undertaken by the manufacturer
or his service agent or a similar qualified
person.
• The drive shall be disconnected from its pow-
er source during cleaning, maintenance and
when replacing parts.
• Warning: Before installing the drive, remove
any unnecessary cords and disable any
equipment not needed for powered operation.
• Install the actuating member of a manual re-
lease at a height of less than 1.8 m.
• Hazardous unprotected moving parts of the
drive shall be installed higher than 2.5 m
above the floor or other level that could pro-
vide access to it.
• The mass and the dimension of the driven
part shall be compatible with the rated torque
and rated operating time.
• The actuating member of a biased-off switch
is to be located within direct sight of the driv-
en part but away from moving parts. It is to
be installed at a minimum height of 1.5 m.
• Install the motor and accessories in strict
accordance with the instructions.
• Do not allow children to play with fixed
controls. Keep remote controls away from
children.
• Check regularly whether installation is off
balance, spring screws are loose, worn or
damaged. Stop using the motor if it is dam-
aged or in need of maintaining.
34 EN
• Do not store with strong acid, alkaline, dirty
or eroding materials.
• Do not use in humid or damp environment.
• Do not start the motor unnecessarily often or
overload it as this might reduce its lifetime.
• Do not work regulating elements in non-oper-
ative status.
• A horizontal distance of at least 0.4 m is to be
maintained between the fully extended awn-
ing and any permanent object.
• Fixed controls have to be visible after instal-
lation.
• The rated operating time is 4 minutes. The
appliance can not be restarted until motor
has cooled down to ambient temperature.
• Do not operate the product while maintaining
works are carried out in the vicinity, like win-
dow cleaning, etc.
• The power supply cable shall only be re-
placed by a cable of the same type, delivered
by the manufacturer.
• Only use tubular motors which correspond to
the local conditions in terms of their output.
Incorrectly dimensioned tubular motors can
lead to damage:
- An insufficiently dimensioned tubular motor
can be damaged due to overloading.
- An excessively dimensioned tubular motor
can cause damage, for example, to the roll-
er shutters and roller shutter casing when
configuring the automatic end-point setting.
For use of batteries
• CAUTION! Explosion hazard when the
batteries are not replaced correctly.
Only replace by batteries of the same
type. Ensure correct polarity.
• Do not expose batteries to excessive
heat from sunlight, fire, etc. Protect
from mechanical shocks. Keep dry and
clean. Keep out of reach of children.
• Do not open, disassemble, cut open, or
short-circuit batteries. Do not use old
and new batteries together.