Nilfisk SW8000 Mode D'emploi page 22

A-22 / ENGLISH
TROUBLESHOOTING
If the possible causes listed below are not the source of trouble, it is a symptom of something more serious. Contact your Nil¿ sk Service Center
immediately for service.
MACHINE WILL NOT START
Possible causes may be:
1 FWD / REV Drive Pedal not in neutral position (ensure pedal is in neutral position)
2 FWD / REV Drive Pedal neutral position is not correctly set (contact your service center)
3 Battery is not connected or dead (connect or charge battery)
4 Machine is out of fuel or LPG tank valve is not open (refuel or open LPG tank valve)
5 Tripped circuit breaker(s) (reset any tripped circuit breakers)
MACHINE WILL NOT MOVE
Possible causes may be:
1 Parking Brake (F) set (release parking brake)
2 Towing Valve in wrong position (set correctly)
3 Tripped circuit breaker(s) (reset any tripped circuit breakers)
MAIN BROOM WILL NOT RUN
Possible causes may be:
1 Engine not set to high RPM (push Engine Speed Switch (GG))
2 Debris wrapped around the broom drive (remove debris)
3 Hopper is not completely down (lower hopper completely)
4 Tripped circuit breaker(s) (reset any tripped circuit breakers)
SIDE BROOM WILL NOT RUN
Possible causes may be:
1 Engine not set to high RPM (push Engine Speed Switch (GG))
2 Ensure Side Broom OFF switch isn't selected (push switch to turn ON)
3 Debris wrapped around the broom drive (remove debris)
4 Hopper is not completely down (lower hopper completely)
5 Tripped circuit breaker(s) (reset any tripped circuit breakers)
HOPPER WILL NOT RAISE
Possible causes may be:
1 Engine not set to high RPM (push Engine Speed Switch (GG))
2 Tripped circuit breaker(s) (reset any tripped circuit breakers)
HOPPER DUMP DOOR WILL NOT OPEN
Possible causes may be:
1 Dump door jammed by debris (remove debris and clean edges of dirt chamber)
2 Tripped circuit breaker(s) (reset any tripped circuit breakers)
SHAKER MOTOR WILL NOT RUN
Possible causes may be:
1 Tripped circuit breaker(s) (reset any tripped circuit breakers)
2 Electrical connection to shaker motor disconnected (connect shaker motor)
DUST CONTROL SYSTEM (IMPELLER) WILL NOT RUN
Possible causes may be:
1 Tripped circuit breaker(s) (reset any tripped circuit breakers)
2 Ensure Dust Control OFF switch isn't selected (push switch to turn ON)
DUSTGUARD™ SIDE BROOM MIST SYSTEM WILL NOT FUNCTION
Possible causes may be:
1 DustGuard™ Switch (VV) not turned ON (turn ON DustGuard™ Switch)
2 Main Broom Lever (B) not actuated (lower main broom)
3 Water tank is empty (¿ ll water tank (28))
4 Spray Nozzles (15) are clogged (clean Spray Nozzles (15))
A-22 - FORM NO. 56091188 - SW8000 4/2015