Registering The Throttle; Electric System - GOLDONI BASE Série Manuel D'emploi Et Entretien

5.5.3 Registering the throttle

This registration is done with the two adjuster screws located
one on the accelerator handle (n.18 fig.1) and the other at the engine end of the
cable.

5.6 ELECTRIC SYSTEM

- Battery
Check and keep the electrolyte level so that all battery elements are covered. As
necessary, add distilled water with the engine switched off and away from naked
flames. Check battery clamp fixing performance and grease them with Vaseline.
Keep the battery clean and if the tractor is not used for a long time, remove the
battery and store it in a cool dry place.
- Fuses:
Before changing a fuse, eliminate the problem that caused it to blow. The fuses
protect the following circuits (Fig.9):
A = Front right – rear left parking light (7.5A)
B = Low beams (10A)
C = Regulator (10A)
D = Front left – rear right parking light (7.5A)
E = High beams (10A)
F = Indicator lights, turn signals and horn (10A)
Change the fuses with others having the same power rating as printed on each
fuse.
The tractor's electric system is also protected by a maxi knife-blade fuse rated at
50 A located inside the dashboard.
60