Compliance Statement - Marshall MG10 GOLD Manuel Du Propriétaire

COMPLIANCE STATEMENT

(MG15FX, MG30FX & MG50FX)
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes or modifications not expressly approved by the party
responsible for compliance could void the users authority to operate the equipment.
This device complies with CAN ICES-3(B)/NMB-3(B)
PLEASE READ THIS MANUAL CAREFULLY
BEFORE PLUGGING IN.
FOLLOW ALL INSTRUCTIONS AND HEED ALL WARNINGS.
KEEP THESE INSTRUCTIONS.
ENGLISH
MG10 FRONT PANEL FUNCTIONS
1 2 3 4
1. INPUT
Input for your guitar. Use a good quality
guitar cable (i.e. one that's screened/
shielded) to help prevent noise,
interference and unwanted feedback.
2. VOLUME - CLEAN CHANNEL
This control adjusts the volume of the
Clean Channel.
3. CHANNEL SWITCH
This switch allows you to change between
the amp's two channels, Clean and
Overdrive, via the front panel. When
the LED is green, the Clean channel
is engaged. When the LED is red, the
Overdrive channel is engaged.
4. GAIN
This control sets the operating level of the
pre-amp. Simply turn up the Gain control
until the required amount of distortion is
achieved.
5. VOLUME - OVERDRIVE CHANNEL
This control adjusts the volume of the
Overdrive channel. The louder this
channel is set, the 'looser' the amplifier will
sound and feel.
6. CONTOUR
This highly effective tone control works by
modifying the mid-range (body).
7. HEADPHONE OUT
For use when silent practice is the order
of the day. Connection of headphones will
automatically mute the internal speaker.
5 6 7 8 9
8. MP3 IN
If you want to jam to your favourite track,
connect the line out or headphone output
of your player here, adjust the volume of
your player to match that of your guitar
and you've got the perfect 'play-along'
practice system.
9. MAINS
The power switch turns your amplifier on
and off. The Channel switch will light up
when your amplifier is turned on and will
not be lit when the amplifier is switched
off.
Note: The specific mains input voltage rating
that your amplifier has been built for is shown
on the back panel. Before connecting to
the mains electricity supply, always ensure
that your amplifier is compatible with your
electricity supply. If you have any doubt,
please get advice from a qualified technician.
Your Marshall dealer will help you in this
respect.
Warning: Please ensure the amplifier is
switched off and unplugged from the mains
electricity supply before being moved.