Marshall MG10 GOLD Manuel Du Propriétaire page 2

INTRODUCTION
Congratulations on your purchase of this MG Gold amplifier from Marshall Amplification.
The MG provides modern Marshall tones for the player who is on the go.
With your MG you can easily dial in storable sounds and effects including sparkling
clean, rich driven blues, rock tone and heavy distorted metal settings. Every element
from voicing through to the speaker has been carefully designed to give you flexibility at
your fingertips.
From the punchy MG 10 to the powerful MG 50, each MG Gold amplifier is quick to set-
up and delivers time and time again. Whether you are practicing at home or gigging on
the road, the MG Gold not only looks good, it won't let you down.
We hope you enjoy your MG Gold amplifier.
- The Marshall Team
ENGLISH
WARNING! IMPORTANT SAFETY INSTRUCTIONS
WARNING:
Before going any further, make sure that
your amplifier is compatible with your
mains electricity supply. If you have any
doubt, please seek help from a qualified
technician – your Marshall dealer can help
you in this respect.
MAINS INPUT & FUSE:
The specific mains input voltage rating
that your amplifier has been manufactured
for is indicated on the rear panel of the
amplifier. MG50FX: Your amplifier is
provided with a detachable mains (power)
lead, which should be connected to the
MAINS INPUT socket on the rear panel of
the amplifier. The correct value and type
of mains fuse is specified on the rear panel
of each amplifier.
NEVER attempt to bypass the fuse or fit one
of the incorrect value or type.
TRANSPORTING YOUR EQUIPMENT:
Please ensure that your amplifier is
switched off, unplugged from the mains
electricity supply and that all removable
cables have been disconnected from your
equipment before attempting to move it.
IMPORTANT SET UP INFORMATION:
WARNING:
Failure to select the correct impedance
may damage your amplifier.
If connecting a speaker cabinet make sure
that you use a proper speaker cable. Never
use a screened (shielded) guitar cable for
this purpose.
1. Ensure that the MAINS (power)
switch is set to the OFF position.
2. Connect the supplied mains (power)
lead into the MAINS INPUT first and
then into the mains electricity supply.
3. Ensure that the VOLUME controls on
the front panel are set to zero.
4. Plug your guitar into an INPUT jack
socket.
5. Turn the front panel MAINS switch to
the ON position.
6. Turn the VOLUME up to your
preferred level and your amplifier is
ready to play.
ENGLISH