Operating Instructions; Main Power Button - Dyna-Glo EG7500DH Guide D'instructions

OPERATING INSTRUCTIONS

WARNING
The heater must be properly installed before it is used.
Control Panel
Check that the garage heaters outlet grill is not covered or obstructed in anyway,
and make sure the power to the unit is switched on.
The garage heater control functions can be accessed in two (2) ways:
• Using the touchpad control panel, located on the front of the garage heater
below the air guide plates.
• Using the multifunction remote control unit.

1. Main Power Button:

This button supplies power to all of the garage heaters functions. It must be
turned on for the garage heater to work
2. Heater Control Button:
This button adjusts the 3 heating stages: OFF Fa (Fan Only) LOW (5000W
displays "L"), High (7500W displays "H").
3. Temperature/Timer Display:
This LED display shows the set point for the temperature and timer functions.
When either of these functions is activated, the display reflects the set point
for five seconds and then fades to black. Any change to he set point of the
temperature or timer will reactivate the display, which again fades after five
seconds.
11