Table Des Matières; Manual Contents; Introduction; Products Covered By This Manual - Allmand Night-Lite Pro II Manuel D'utilisation

Record Important Information
Recording the equipment information will help when placing
an order for replacement parts and/or decals.
Company Equipment No:
Unit Model No:
Unit VIN:
Engine Model No:
Generator Model No:
Accessories:

Manual Contents:

Introduction........................................................................... 2
Products Covered by This Manual......................................2
Safety......................................................................................2
Features And Controls......................................................... 9
Pre-Operation Checklist..................................................... 10
Transporting........................................................................ 11
Operation............................................................................. 17
Maintenance.........................................................................24
Troubleshooting.................................................................. 28
Specifications...................................................................... 28
Addendum - Unit Options.................................................. 30

Introduction

About This Manual
TAKE TIME TO READ THIS MANUAL THOROUGHLY
This instruction manual provides necessary instructions for
®
the Allmand Night-Lite Pro II
The information found in this manual is in effect at the time
of printing. Briggs & Stratton, LLC.
without notice and without incurring obligation.
The images throughout this manual are representative, and
may differ from your model.
Any reference in this manual to left or right shall be
determined by looking at the trailer from the rear.
If uncertain about any of the information in the
manual, contact the Allmand service department at
1-800-562-1373, or contact us through the Allmand website,
www.allmand.com.
Save these original instructions for future reference.
Products Covered by This
Manual
The following products are covered by this manual:
®
Night-Lite Pro II
2
Serial No:
Serial No:
®
Light Tower.
may change contents

Safety

Safety Definitions

For your safety, the safety of others, and to protect the
performance of equipment, follow the precautions listed
throughout the manual before operation, during operation and
during periodic maintenance procedures.
Indicates a potential personal injury hazard.
DANGER
Indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING
Indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION
Indicates a hazardous situation which, if not avoided, could
result in minor or moderate injury.
NOTICE
Information considered important but not hazard related.
Safety Precautions
The following section contains general safety precautions
and guidelines that must be obeyed to reduce risk to
personal safety. Special safety precautions are listed in
specific procedures. Read and understand all of the safety
precautions before operating or performing repairs or
maintenance.
DANGER
Electrocution Hazard
• Always check overhead wires and obstructions before
raising or lowering the light tower.
• Always obey the rules or instructions for your work
site and state, province and national electric code for
maintaining a safe distance from overhead wires.
• High voltage is present when engine is running. Never
attempt to service electrical components while engine is
running.
• Do not operate the light tower if the insulation on the
electrical cord or other electrical wiring is cut or worn or
if bare wires are exposed. Repair or replace damaged
wiring before starting the engine.